Injection Molding

With operating temperatures between -350 to +1000°F (-188° to +538° C) the Dynacron dry film lubrication process will significantly improve the part release and material flow for most high-density plastics, including; polycarbonate, polyethylene, polypropylene, ABS, polycarbonate, and styrene. The improved flow characteristics and part release permit lower temperature and pressure requirements while producing a significant reduction in cycle times. In addition, the improved release eliminates or minimizes flash, sticking, scuffing, and other blemishes. Dynacron reduces friction and breakage for ejector pins and improves lubricity and reduces wear on gibs, slides, lifters, leader pins, and bushings.

• Modified tungsten disulfide (WS2) compound
• Only 0.5 micron (0.000020″) buildup, uniform dry film coating
• Molecular bonding
• Will not crack or peel from metal surface
• Applied at room temperature
• Retains surface finish and original dimensions
• Can be applied to almost all substrates
• Lubricates in a wide temperature range, -350° to +1000° F (-188° to +538° C)

• Provides the lowest co-efficient of friction (0.030 dynamic)
• Anti-Galling & Anti-Seizing, eliminates “Stick-Slip”
• Compatible with other lubricants
• Reduces noise
• Environmentally friendly, inert, and non-toxic

Leave a Reply

Your email address will not be published. Required fields are marked *

Fill out this field
Fill out this field
Please enter a valid email address.
You need to agree with the terms to proceed