Tooling & Cutting Dies

Dynacron can be applied to all PVD and CVD coatings in addition to all Ferrous and non-ferrous substrates. The extremely low coefficient of friction improves chip evacuation on cutting tooling and significantly reduces galling material adhesion, and residual pickup. Dynacron has been used successfully on end mills, saw blades, and drill bits. It is also an excellent addition to chucks, tooling holders, and die components.

• Modified tungsten disulfide (WS2) compound
• Only 0.5 micron (0.000020″) buildup, uniform dry film coating
• Molecular bonding
• Will does not crack or peel from the metal surface
• Applied at room temperature
• Retains surface finish and original dimensions
• Can be applied to almost all substrates
• Lubricates in a wide temperature range, -350° to +1000° F (-188° to +538° C)

• Provides the lowest co-efficient of friction (0.030 dynamics)
• Anti-Galling & Anti-Seizing eliminates “Stick-Slip”
• Compatible with other lubricants
• Reduces noise
• Environmentally friendly, inert, and non-toxic

Leave a Reply

Your email address will not be published. Required fields are marked *

Fill out this field
Fill out this field
Please enter a valid email address.
You need to agree with the terms to proceed